This page describes the channel setting and how to change it.
Each Frequency has ten channels that can be used to sub divide radio traffic. There are ten channels supported by our devices.
For two devices to communicate they must have the same Frequency and Channel and PanID.
Channel Default Setting
Default is 0.
How to change the Channel
The Channel can be changed using the ATCN command.
Command: ATCN[p1]
Response: ATCN[p1]
Where: p1 = A number between 1 and 10
The below example changes the Channel to 4:
python rf_config.py 03 ATCN4
SENT : 03ATCN4
RECEIVED : 03ATCN4----
The device requires a restart in order to effect the new Channel.